pneumatic drilling machine：
feature:
- Light weight, small size, easy to operate
- Gears with high precision and long service life
- Built-in silencer to reduce noise
- Easy to hold with one hand
Product Information:
~~Welcome to inquire~~
air tool Instructions for use and care The instructions for use of pneumatic tools are to deliver dry and low-temperature compressed air through clean piping , Requires a three-point assembly between hard and rubber hose 1. Air tool oil : Regular rotation and permanent mechanical life for pneumatic tools , Be sure to add pneumatic maintenance oil. (1) motor part : daily before use, please inject from the oil port after use 2~3cc pneumatic lubricating oil / Pneumatic maintenance oil. (2) clutch part : 每 1 Months to wash the old butter out of the clutch , Then apply a generous amount of new butter , But if you inject too much butter , Please note that it will reduce the function !
with oil hole , Screws should be removed monthly , Add a little. 2. Air Compressor Management : Pneumatic tools must use low-temperature clean and dry compressed air with a fixed air pressure and sufficient air volume. (1) Air compressor be usable 2HP standard compressor (2) air pressure Please use standard air pressure ,5~7kg/cm2 If higher air pressure is used , will enhance the ability , But it will shorten the life of pneumatic tools a lot , So please avoid. (3) Elimination of impurities and moisture Impurities and moisture in the compressor are eliminated even if , But hard tube and rubber tube , there will still be a little , Therefore, when loading and unloading pneumatic tool hoses and adapters, please try to remove impurities and moisture as much as possible. 3. air tool running : (1) Please run freely for a few seconds after oil filling. (2) engine running : turn left and right R 壓 , Buckle 機 , It is the lever when locking the screw L pull the trigger , Do not switch in a slew. (3) adjustment ability : After tightening the screws ,1/2 turn around ( 約 1 秒 ) Rotary stop , Properly screwed in and it's over , Adjust the upper scale of the regulator , The necessary ability can be obtained. (4) usual screws , 約 2~3 can be installed in seconds , 若 5 More than seconds operation , Screws that cannot be loosened and screws that cannot be torqued , A higher capacity air tool should be used. (5) when machinery falls from above , Don't knock, hammer, etc. indiscriminately , Please have it ruled out by a professional (6) Rusted and cracked sockets , Please avoid using it. caution ! Maintenance is better than repair !
Sales method: manufacturing
Sales target market: Taiwan
Inquiry payment method: TT wire transfer, L/C letter of credit
Competitive Features
Various designs: HSIEH CHIEN AIR ACTIVATION CO., LTD. provides various designs of pneumatic drills
Pneumatic drill accepts original factory entrusted design and manufacture ODM
Pneumatic drills are accepted for OEM commissioned by the original factory
