Pneumatic abrasive cloth belt machine - chariot
Product Description :
● Model: HC-RMB1
● Dimensions: 60x260
● Length: 170
● Load speed: 7000
● Air disinfection Consumption: 8.8cfm
● Operating pressure: 90
● Weight: 1.1
~~Welcome to inquire~~
air toolInstructions for use and care
The instructions for use of pneumatic tools are to deliver dry and low-temperature compressed air through clean piping,Requires a three-point assembly between hard and rubber hose
1.Air tool oil:
Regular rotation and permanent mechanical life for pneumatic tools,Be sure to add pneumatic maintenance oil.
daily before use,Please inject from the oil port after use2~3ccpneumatic lubricating oil/Pneumatic maintenance oil.
每1Months to wash the old butter out of the clutch,Then apply a generous amount of new butter,But if you inject too much butter,Please note that it will reduce the function!
with oil hole,Screws should be removed monthly,Add a little.
2.Air Compressor Management:
Pneumatic tools must use low-temperature clean and dry compressed air with a fixed air pressure and sufficient air volume.
be usable2HPstandard compressor
Please use standard air pressure,5~7kg/cm2If higher air pressure is used,will enhance the ability,But it will shorten the life of pneumatic tools a lot,So please avoid.
(3)Elimination of impurities and moisture
Impurities and moisture in the compressor are eliminated even if,But hard tube and rubber tube,there will still be a little,Therefore, when loading and unloading pneumatic tool hoses and adapters, please try to remove impurities and moisture as much as possible.
3.air tool running:
(1)Please run freely for a few seconds after oil filling.
turn left and rightR壓,Buckle 機,It is the lever when locking the screwLpull the trigger,Do not switch in a slew.
After tightening the screws,1/2turn around(約1秒)Rotary stop,Properly screwed in and it's over,Adjust the upper scale of the regulator,The necessary ability can be obtained.
(4)usual screws,約2~3can be installed in seconds,若5More than seconds operation,Screws that cannot be loosened and screws that cannot be torqued,A higher capacity air tool should be used.
(5)when machinery falls from above,Don't knock, hammer, etc. indiscriminately,Please have it ruled out by a professional
(6)Rusted and cracked sockets,Please avoid using it.
caution!Maintenance is better than repair!
Sales method: manufacturing
Sales target market: Taiwan
Inquiry payment method: TT wire transfer, Check check
Various designs: HSIEH CHIEN AIR ACTIVATION CO., LTD. provides diversified designs of pneumatic abrasive cloth belt machines
Pneumatic emery cloth ring belt machine accepts original factory commissioned design and manufacture ODM
Pneumatic emery cloth ring belt machine accepts OEM commissioned by the original factory